top of page

INSTRUCTIONS:
Plan the placement of the poster in your project
Apply Mod Podge or PVA glue to the back of the print and apply directly to your project with a brush or roller.
Place your poster on your project and smooth out any air bubbles with our adhesive blue decoupage tool.
Use the felt side of our self-adhesive blue decoupage tool to push the air bubbles out from the center of the project to the sides to avoid damaging the image.
Your print will come with a protective film so only the edges and any cuts or penetrations that penetrate the film need to be sealed. If you wish to seal the print to achieve the same finish as your furniture, apply a THIN coat of polyurethane sealer or water based top coat before applying other finishes.
DO NOT apply PVA glue to the print surface like you would with other styles of decoupage.
DO NOT use an iron, heat or water.
Always use a water based sealer or top coat!

Aussie "Red Jewelled Spider" Poster Print

PriceFrom €13.27
VAT Included
  • Poster print 0.2mm thick.

    Comes with a water resistant film on the front of the print.

    Available in:

    A2 - 59.4cm x 42cm or 23.38" x 16.53"

    and A3 - 42cm x 29.7cm or 16.5" x 11.7"